floor

Device Config Commands

Sets the building floor name representative of the location within the area or building the device (controller, service platform, or access point) is physically deployed. Assigning a building floor name is helpful when grouping devices in RF Domains and profiles, as devices on the same physical building floor may need to share specific configuration parameters in respect to radio transmission and interference requirements specific to that location.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

floor <FLOOR-NAME> <1-4094>

Parameters

floor <FLOOR-NAME> <1-4094>


floor <FLOOR-NAME> <1-4094>	Sets the building floor name where the device is deployed <1-4094> – Sets a numerical floor designation in respect to the floor‘s actual location within a building. Specify a value from 1 - 4094. The default setting is the 1st floor.

Example

nx9500-6C8809(config-device-94-9B-2C-13-3E-1C)#floor 5thfloor

nx9500-6C8809(config-device-94-9B-2C-13-3E-1C)#show context
ap505 94-9B-2C-13-3E-1C
 use profile default-ap505
 use rf-domain default
 hostname ap505-133E1C
 area RMZEcospace
 floor 5thfloor
 contact Bob+1-631-738-5200
 country-code us
 channel-list 2.4GHz 1,2
nx9500-6C8809(config-device-94-9B-2C-13-3E-1C)#

Related Commands


no	Removes device‘s location floor name